Kicker 48KXMA4002 - 2-channel marine amplifier — 100 watts RMS x 2

Powerful, dependable, and good-looking

Kicker's KXMA400.2 marine 2-channel amplifier will bring brilliance and clarity to your sound, powering two speakers with 100 watts RMS each. This reliable and compact KXM Series rocker will run cool even when pushed hard, thanks to its high-mass heatsink, high-tech internal components, and efficient full-range Class-D amp technology. Building a big system piece-by-piece? You could start by using this amp in 1-channel mode to drive a sub with 400 watts, and then later switch the amp back to 2-channel mode to power your speakers when you get a bigger amp for the sub.

Made for marine use

The KXMA400.2 features a conformal-coated circuit board for improved water and dust resistance, plus corrosion-resistant power connections, a gasket-sealed front cover, and stainless steel mounting hardware that won't rust all over your boat's gel coat or carpeting.

Connection perfection

Kicker employs their Fail-Safe Integration Technology (FIT2™) to reject noise and stop any interference generated by your boat's electronics, so you'll enjoy your music clean and pure. Speaker-level inputs make it possible to hook this amp up to almost any stereo receiver or radio. Kicker also helps you set this amp's gain properly, by offering free test tones for downloading. You play a tone and turn the gain up until the gain knob glows red. Then, you turn it down until it just goes out, and the amp's gain is set perfectly.

Versatile controls behind the folding door

A gasket-sealed front door gives you quick and easy access to your amp's controls. You can tune for almost any kind of speaker, as the steeply-sloped high- and low-pass filters offer a wide range of adjustment. The filters can be set up for bandpass operation — where both the high- and low-pass filters are engaged to allow only the frequencies between them to play — for optimizing the signal for midrange speakers in a 3-way system.

Product highlights:

• 2-channel marine amplifier
• 100 watts RMS x 2 at 4 ohms (200 watts RMS x 2 at 2 ohms)
• 400 watts RMS x 1 bridged at 4 ohms (4-ohm stable in bridged mode)
• CEA-2006 compliant
• Class D amp technology
• gain knob also functions as clip light
• variable high-pass filter (10-500 Hz, 24 dB/octave)
• variable low-pass filter (40-500 Hz, 24 dB/octave) with 10x switch
• bandpass engages both high- and low-pass filters
• variable bass boost (0-6 dB at 40 Hz)

Weight: 7.25 lb